How To Put Weedeater String On

Written by US Indian on March 05 2023

How To Put Weedeater String On?

Replacing the string in your weedeater is essential for keeping your lawn looking neat and tidy. The process may seem daunting if you’ve never done it before, but it’s actually quite easy. To put new string on a weedeater, you’ll need a few simple tools and a bit of time.

The first step is to purchase the correct string for your weedeater. Most weedeaters require a certain type of string, so make sure you check the manual for your model before you buy to make sure you’re getting the right type. Once you’ve purchased the correct string, you’re ready to begin.

Here’s a step-by-step guide to putting weedeater string on:

Disconnect the spark plug wire from the spark plug. This will ensure that the weedeater won’t start while you’re working on it.
Unscrew the spool cover from the weedeater and remove the old spool of string.
Cut a length of new string that is about twice as long as the spool. Wrap one end of the string around the spool and use your fingers to hold it in place.
Pull the string through the eyelet at the bottom of the spool, then wind it around the spool in a figure-eight pattern, making sure to leave some slack in the string.
Once the spool is full, cut the string and tie a knot at the end.
Replace the spool in the weedeater and screw the spool cover back on.
Reconnect the spark plug wire to the spark plug and you’re done!

Replacing the string in your weedeater is an easy process that only takes a few minutes. With the right tools and a bit of patience, you can have your weedeater running in no time. Just make sure to check the manual for your model before you purchase the replacement string and you’ll be all set.

Restring a 2 sided spool on a string trimmer weed eater EASY!!

How To Put Weedeater String On. Restring a dual sided spool string trimmer weed eater String trimmer line on Amazon. amzn.to/2QHzo6x String trimmer on Amazon with good reviews. amzn.to/2OAzOdl This is a nice string trimmer, it uses to 2 strings on a dual spool, people may call them weedwhacker, weed eater, string trimmer, etc , but this is basically a machine that can be used for mowing grass edging sidewalks and roads they can even be used against plants. I believe...

Install the Trimmer String You can also replace the trimmer line on the existing spool. Remove the spool cap and old spool and cut approximately 20 feet of the. There are two ways to use a weed eater as an edger. The first is to use an edger attachment. The second method is to hold the tool at a 90 degree angle. You are.